Wall of Frames 2024
The College of Engineering & Architecture hosts the Wall of Frames which was opened on December 2nd 2015. There are 24 Publications on display and this selection has been identified as being of particular significance in the calendar year of 2023 due to their impact and diversity.
School of Architecture Planning & Environmental Policy
(opens in a new window)A whole life carbon analysis of the Irish residential sector - past, present and future
This paper presents the findings of research carried out at UCD by (opens in a new window)Dr Richard O’Hegarty and (opens in a new window)Assoc Prof Oliver Kinnane of the School of Architecture, Planning & Environmental Policy.
The outputs from this research contribute to the UN Sustainable Development Goals: (opens in a new window)SDG 11 | (opens in a new window)SDG 12
(opens in a new window)Managed retreat and coastal climate change adaptation: The environmental justice implications and value of a coproduction approach
This paper presents the findings of research carried out at UCD by (opens in a new window)Assoc Prof Mick Lennon and (opens in a new window)Prof Mark Scott of the School of Architecture, Planning & Environmental Policy.
The outputs from this research contribute to the UN Sustainable Development Goals: (opens in a new window)SDG 11 | (opens in a new window)SDG 16
(opens in a new window)Investigating changes in noise pollution due to the COVID-19 lockdown: The case of Dublin, Ireland
This paper presents the findings of research carried out at UCD by (opens in a new window)Prof Enda Murphy, (opens in a new window)Dr Anna Molter, and (opens in a new window)Prof Francesco Pilla of the School of Architecture, Planning & Environmental Policy.
The outputs from this research contribute to the UN Sustainable Development Goals: (opens in a new window)SDG 3 | (opens in a new window)SDG 11
(opens in a new window)Maybe tomorrow: How burdens and biases impede energy-efficiency investments
This paper presents the findings of research carried out at UCD by (opens in a new window)Prof Leo Lades, (opens in a new window)Prof Peter Clinch, and (opens in a new window)Dr James Andrew Kelly, an Adjunct Associate Professor, of the School of Architecture, Planning & Environmental Policy.
The outputs from this research contribute to the UN Sustainable Development Goals: (opens in a new window)SDG 7 | (opens in a new window)SDG 11 | (opens in a new window)SDG 13
School of Biosystems & Food Engineering
(opens in a new window)Ranking of potential hazards from microplastics polymers in the marine environment
This paper presents the findings of research carried out at UCD by (opens in a new window)Dr Rajat Nag, and (opens in a new window)Prof Enda Cummins of the School of Biosystems and Food Engineering.
The outputs from this research contribute to the UN Sustainable Development Goals: (opens in a new window)SDG 14
(opens in a new window)The effect of atmospheric cold plasma treatment on the antigenic properties of bovine milk casein and whey proteins
This paper presents the findings of research carried out at UCD by (opens in a new window)Prof Paula Bourke of the School of Biosystems and Food Engineering, and research by (opens in a new window)Dr Daniela Boehm, formerly of TU Dublin and now of UCD School of Chemical & Bioprocess Engineering.
The outputs from this research contribute to the UN Sustainable Development Goals: (opens in a new window)SDG 3 | (opens in a new window)SDG 9 | (opens in a new window)SDG 12
(opens in a new window)Life cycle assessment of sewage sludge pre-treatment for biogas production: From laboratory tests to full-scale applicability
This paper presents the findings of research carried out at UCD by (opens in a new window)Ms Charlene Vance and (opens in a new window)Dr Fionnuala Murphy of the School of Biosystems and Food Engineering.
The outputs from this research contribute to the UN Sustainable Development Goals: (opens in a new window)SDG 7 | (opens in a new window)SDG 8 | (opens in a new window)SDG 9 | (opens in a new window)SDG 11 | (opens in a new window)SDG 12 | (opens in a new window)SDG 13
(opens in a new window)Spectral imaging for characterization and detection of plastic substances in branded teabags
This paper presents the findings of research carried out at UCD by (opens in a new window)Dr Junli Xu, (opens in a new window)Dr Ana Herrero-Langreo, and (opens in a new window)Prof Aoife Gowen of the School of Biosystems and Food Engineering.
The outputs from this research contribute to the UN Sustainable Development Goals: (opens in a new window)SDG 3
School of Chemical & Bioprocess Engineering
(opens in a new window)Synthesis and self-assembly of curcumin-modified amphiphilic polymeric micelles with antibacterial activity
This paper presents the findings of research carried out at UCD by (opens in a new window)Dr Dishon Hiebner and (opens in a new window)Prof Eoin Casey of the School of Chemical and Bioprocess Engineering.
The outputs from this research contribute to the UN Sustainable Development Goals: (opens in a new window)SDG 3
(opens in a new window)Operational challenges for low and high temperature electrolyzers exploiting curtailed wind energy for hydrogen production
This paper presents the findings of research carried out at UCD by (opens in a new window)Dr Eoin Syron of the School of Chemical and Bioprocess Engineering and (opens in a new window)Assoc Prof Damian Flynn of the School of Electrical & Electronic Engineering.
The outputs from this research contribute to the UN Sustainable Development Goals: (opens in a new window)SDG 7
(opens in a new window)Tracking the Behavior of Monoclonal Antibody Product Quality Attributes Using a Multi-Attribute Method Workflow
(opens in a new window)Prof Jonathan Bones of the School of Chemical and Bioprocess Engineering and NIBRT.
The outputs from this research contribute to the UN Sustainable Development Goals: (opens in a new window)SDG 3
(opens in a new window)Upcycling natural Limestone waste for thermochemical energy storage by utilising tailored CaZrO3 Nano additives
This paper presents the findings of research carried out at UCD by (opens in a new window)Dr Veronica Sofianos of the School of Chemical and Bioprocess Engineering.
The outputs from this research contribute to the UN Sustainable Development Goals: (opens in a new window)SDG 7
School of Civil Engineering
(opens in a new window)A fault diagnosis framework for autonomous vehicles with sensor self-diagnosis
This paper presents the findings of research carried out at UCD (opens in a new window)Dr Rui Teixeira of the School of Civil Engineering.
The outputs from this research contribute to the UN Sustainable Development Goals: (opens in a new window)SDG 9 | (opens in a new window)SDG 11 | (opens in a new window)SDG 12
(opens in a new window)A kNN algorithm for locating and quantifying stiffness loss in a bridge from the forced vibration due to a truck crossing at low speed
This paper presents the findings of research carried out at UCD by Dr Kun Feng, (opens in a new window)Assoc Prof Arturo González, and (opens in a new window)Dr Miguel Casero Flórez, of the School of Civil Engineering.
The outputs from this research contribute to the UN Sustainable Development Goals: (opens in a new window)SDG 9
(opens in a new window)A data-driven approach for drive-by damage detection in bridges considering the influence of temperature change
This paper presents the findings of research carried out at UCD by Mr Robert Corbally and (opens in a new window)Dr Abdollah Malekjafarian of the School of Civil Engineering.
The outputs from this research contribute to the UN Sustainable Development Goals: (opens in a new window)SDG 9 | (opens in a new window)SDG 11 | (opens in a new window)SDG 13
(opens in a new window)Intermittent water supply systems and their resilience to COVID-19: IWA IWS SG survey
This paper presents the findings of research carried out at UCD by Dr Sarah Cotterill of the School of Civil Engineering.
The outputs from this research contribute to the UN Sustainable Development Goals: (opens in a new window)SDG 3 | (opens in a new window)SDG 6 | (opens in a new window)SDG 9
School of Electrical & Electronic Engineering
(opens in a new window)A 0.02-4.5-GHz LN(T)A in 28-nm CMOS for 5G Exploiting Noise Reduction and Current Reuse
This paper presents the findings of research carried out at UCD by Dr Amir Bozorg and (opens in a new window)Prof Robert Bogdan Staszewski, of the School of Electrical and Electronic Engineering.
The outputs from this research contribute to the UN Sustainable Development Goals: (opens in a new window)SDG 11
(opens in a new window)Waveform Engineered Sequential Load Modulated Balanced Amplifier with Continuous Class-F-1and Class-J Operation
This paper presents the findings of research carried out at UCD (opens in a new window)Prof Anding Zhu of the School of Electrical and Electronic Engineering.
The outputs from this research contribute to the UN Sustainable Development Goals: (opens in a new window)SDG 11
(opens in a new window)A Wide-Range High-Voltage-Gain Bidirectional DC-DC Converter for V2G and G2V Hybrid EV Charger
This paper presents the findings of research carried out at UCD by (opens in a new window)Dr Hamed Heydari-Doostabad and (opens in a new window)Assoc Prof Terence O’Donnell of the School of Electrical and Electronic Engineering.
The outputs from this research contribute to the UN Sustainable Development Goals: (opens in a new window)SDG 7
(opens in a new window)Estimation of respiratory rate and exhale duration using audio signals recorded by smartphone microphones
This paper presents the findings of research carried out at UCD by (opens in a new window)Dr Emer Doheny and (opens in a new window)Prof Madeleine Lowery of the School of Electrical and Electronic Engineering, and members of the Insight SFI Research Centre for Data Analytics.
The outputs from this research contribute to the UN Sustainable Development Goals: (opens in a new window)SDG 3
School of Mechanical & Materials Engineering
(opens in a new window)Challenges and recent developments in supply and value chains of electric vehicle batteries: A sustainability perspective
This paper presents findings from research carried out at UCD by (opens in a new window)Dr Pezhman Ghadimi, of the School of Mechanical and Materials Engineering.
The outputs from this research contribute to the UN Sustainable Development Goals: (opens in a new window)SDG 7 | (opens in a new window)SDG 9 | (opens in a new window)SDG 12
(opens in a new window)Investigating the fatigue and mechanical behaviour of 3D printed woven and nonwoven continuous carbon fibre reinforced polymer (CFRP) composites
This paper presents findings from research carried out at UCD by (opens in a new window)Prof Denis Dowling of the School of Mechanical and Materials Engineering and Director of I-Form, SFI Centre for Advanced Manufacturing.
The outputs from this research contribute to the UN Sustainable Development Goals: (opens in a new window)SDG 9
(opens in a new window)A fundamental unified framework to quantify and characterise energy flexibility of residential buildings with multiple electrical and thermal energy systems
This paper presents findings from research carried out at UCD by (opens in a new window)Prof Donal Finn of the School of Mechanical and Materials Engineering, and member of the UCD Energy Institute.
The outputs from this research contribute to the UN Sustainable Development Goals: (opens in a new window)SDG 3
(opens in a new window)Insights into the mechanics of solid conical microneedle array insertion into skin using the finite element method
This paper presents findings from research carried out at UCD by (opens in a new window)Assoc Prof Eoin O’Cearbhaill and (opens in a new window)Assoc Prof Aisling Ní Annaidh of the School of Mechanical and Materials Engineering, and members of UCD Centre for Biomedical Engineering.
The outputs from this research contribute to the UN Sustainable Development Goals: (opens in a new window)SDG 3